Tips For Troubleshooting Your Home Alarm System In Oceanside
System glitches and false alarms can be aggravating, and even worse, could prevent your home security system from working how it should. Luckily, most troubles, from dead batteries to false alarms, are straightforward to fix. Check out our suggestions for troubleshooting your home alarm system in Oceanside. We’ll help keep your family shielded and your system operating properly.
Test Your Home Security System In Oceanside
One effective way to troubleshoot your home’s security is to test it yourself! Modern systems let you place them in test mode to avoid initiating an emergency response from monitoring agents. Once you’re in test mode, take these steps:
- Arm your system as you typically would when you leave.
- Open a window or door that uses a contact sensor, or try to set off something else. Shut the door or window so it doesn’t trip the alarm when you switch the system back on.
- Let the alarm sound for 60 seconds to make sure a transmission is dispatched to the security company and an entry is created in the alarm activity log.
- Continue testing devices as you wish
- Check the systems’s activity log to confirm functionality.
No need to worry, monitoring professionals will know that your system is being tested. Just be sure to switch off test mode when you’re done. It’s a good idea to test monthly or whenever you change your home’s internet or phone service.
Inspect The Position And Condition Of Motion Sensors
Although an integral element of your alarm system, motion detectors are notorious for false alarms. Do your part to prevent them with some easy troubleshooting.
- Perform a physical inspection. Is there something that could move within the sensor’s detection area, like a window treatment caught in a breeze?
- Is the sensor dirty? Cobwebs, dirt, and grime can lead to issues. Make sure the device is clean.
- Does the motion detector offer pet immunity you can activate? Some models can be set to ignore pets weighing as much as 100 pounds.
- When was the battery last replaced? A nearly depleted battery can affect performance or cause false alarms.
- Is the sensor pointing toward a source of heat? Too much heat from direct sun or a fireplace can set off an alarm.
Keep Batteries On Hand And Look Out For Low Battery Signals
One helpful aspect of the latest home security systems is that they’ll alert you when batteries are dying. If your system uses a mobile app or control panel, you’ll often discover messages there. Depending on your system, you may notice an occasional beep when batteries are getting low.
Contact sensors, smoke detectors, motion sensors, and other wireless tools have batteries that need to be replaced every 1 to 2 years. It’s best to keep batteries around and set a replacement schedule. Many systems also include a backup battery for the central control panel. This backup keeps your system running if your power goes out and should charge back up once the electricity is working again. If it doesn’t recharge, you will need to replace it.
Troubleshooting Is Effortless With ADT Home Security In Oceanside
As the foremost name in home security, ADT creates systems that supply unsurpassed functionality and convenience. Getting into test mode is easy through MyADT.com or the ADT+ app, and you’ll always be sent notifications when a battery is nearing depletion. Reach out to Secure24 Alarm Systems, an authorized ADT dealer, to learn more and design a system perfectly suited to your Oceanside home. Call (760) 230-3571 or complete our form today!